![]() I already owned a KryoFlux by the time I learned of it and my next purchase is probably going to be parts for a sanni reader. There's a chart at that link detailing which formats the software for it currently knows how to write, which is also on the GitHub page for the software. Disk formatting is the process of preparing a data storage device such as a hard disk drive, solid-state drive, floppy disk, memory card or USB flash drive for initial use. If you're poor, you can even use regular pin header and just remember not to connect the cable the wrong way around.) (Basically, you solder one row of the pins on the floppy connector through the holes on a ready-made FPGA development board and assembly is done. You can make one for $15 (plus shipping). No ordering custom boards, no fiddly surface mount assembly, and no fuss: nineteen simpler solder joints and you’re done. ![]() The hardware consists of a single, commodity part with a floppy drive connector soldered onto it. (Although not all of these are supported yet. ![]() It allows you to use a conventional PC drive to accept Amiga disks, CLV Macintosh disks, bizarre 128-sector CP/M disks, and other weird and bizarre formats. Are the floppy disks readable on the old computer Floppy disks are really unreliable, there are common cases where the read/write heads on a drive get mis. The Flu圎ngine is a very cheap USB floppy disk interface capable of reading and writing exotic non-PC floppy disk formats. It may not be formatted.' It does this on both my notebooks Dell Inspiron and Asus If this answers your question - Then mark it so. If you want something more flexible than a USB floppy drive, but barely more expensive, and you're OK with beginner-level through-hole soldering and a command-line interface on the reading/writing tool, take a look at the Flu圎ngine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |